注意报错提示：
2 R) [& J9 T( [0 K' ^7 c646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
; ?2 l W! v) v* q" E2 ?8 \# T646.04: Travel action ignored.1 _- m# u9 z7 L) `- T
646.04: No debugger information is available.
$ Q$ a, q: Y6 j9 o- `' W2 P9 N; x! z8 ?646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.4 ?: v* p1 J. }5 n2 T% b+ E
646.04: Travel action ignored.- c7 \2 Z- \! [7 j5 `
646.04: No debugger information is available. R5 D; h" _# J2 f! [. r I
1 r; x5 w! o1 F% k. l3 K3 B
回来看代码：
# M5 E5 v9 s7 A& e) I& L$ Q
" |! z% W4 Q. Y* b4 jbegin P_output1 arriving procedure3 g, l! s# W0 t1 P6 i( t3 G5 D
travel to Conv.staoutput1
; l1 M4 K$ h! w: }2 c move into Q_output(1)
7 x0 y4 n( V F7 A# V8 Z /*Location to wait for a vehicle*/
2 v; p; s0 K& L8 N- B9 T, { travel to Rgv.cpoutput1 /*Get on Vehicle*/
8 B) Q8 `1 T$ D6 ?- | send to P_store
; O& r+ S; R9 d# Wend + [, c: N1 e7 W1 J
$ W6 ^1 S; J5 r: A: u- H. }1 @begin P_store arriving procedure0 o; |* [# a4 i/ ]3 \" `
travel to Rgv.cpstore0 \) H5 F" k" O$ N$ W3 o
/* Travel onboard vehicle to cpstore */
5 M p! A: i& v- s% M; @ move into Q_store /* Get off vehicle */
s& S, B: Z1 J% U1 \* I/ g wait for 20 sec( }- d& W0 n0 t) {; H9 a
set A_Time to ac - A_Time
+ y3 g. p2 v- ~ print this load, "Time in system " A_Time to message
# F3 Y/ p! q! N' k5 Y$ F inc V_Numdone by 1
! o/ G* n$ i+ O- Z send to die) A4 w9 g: K, f/ f
end
* \+ o/ a7 i$ B% Z. z8 B' I
' v3 ]- _- m6 E% D知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
