求解

am_simulation

RGV在Q_wait1-6取载后在8个工作站净空、lable
! h* ]6 O: E$ }' A( h' O最后在空箱在Q_store流出
* q) x* x6 P8 B5 d目前run model结果发现，货物淤塞在staoutput1-8
8 c- L- R1 N0 g/ z/ r未能流出，求解

zhdew

注意报错提示：
% z* d9 V! d- a  T" v" A0 I& Q646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
2 e# U* j( h& D4 _" V4 M1 P646.04: Travel action ignored.
646.04: No debugger information is available.
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
646.04: Travel action ignored.
: q& ^! N: r. H% O9 T2 }/ E646.04: No debugger information is available.
% @5 l6 g( k+ z7 f7 D) `$ S
回来看代码：

5 Z2 L% d1 P4 rbegin P_output1 arriving procedure
   travel to Conv.staoutput1
   move into Q_output(1)
2 b0 U" q" _( \) s6 I   /*Location to wait for a vehicle*/
1 @5 W4 ]7 b. r) w# E4 ]    travel to Rgv.cpoutput1 /*Get on Vehicle*/
   send to P_store
end  
9 h. U- o8 L- X8 C# ]# X
begin P_store arriving procedure
   travel to Rgv.cpstore
   /* Travel onboard vehicle to cpstore */
   move into Q_store /* Get off vehicle */
! U( f/ `: g' M: ~' Z   wait for 20 sec
3 n4 @5 \+ ?4 ?( i% _) A  n   set A_Time to ac - A_Time
   print this load, "Time in system " A_Time to message
% u1 c; P+ R- [! _' q& m   inc V_Numdone by 1
0 G9 k; T" S" t   send to die
end

知道怎么改了吧？