注意报错提示：7 i" ^ t2 z W1 e
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
& W4 `: }+ H. a, d6 `646.04: Travel action ignored.
0 i3 m3 @. V$ B7 [+ l4 E) G646.04: No debugger information is available.2 f) E% L& P, M: o$ v2 ^
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.- u& a% J/ r6 o+ B, z2 B" [) n
646.04: Travel action ignored.2 c4 a6 ^" U" [
646.04: No debugger information is available.0 O; h) m" h9 H! m
+ A! y* m6 J$ s6 C a) Y. h
回来看代码：
& d+ Y1 \2 S+ u8 a5 N$ q8 T0 o& L' u9 _3 A! c, p
begin P_output1 arriving procedure% \7 M5 W/ p, L. S# I: I, m& F
travel to Conv.staoutput1
6 b( r9 U* ]# u" T. B. s/ w' y move into Q_output(1)
c. `; T% k0 @# A" G. l# ~3 D- R /*Location to wait for a vehicle*/
0 c- l3 n1 x' |6 d travel to Rgv.cpoutput1 /*Get on Vehicle*// R5 g, p$ A9 C4 }; ]
send to P_store$ E' l8 G& y* l, l5 {; G/ _1 d6 x
end
& p4 |- V& O; n; p1 f# m4 e7 Z* r0 ?3 A+ d6 X( N
begin P_store arriving procedure
/ r$ b1 v/ o% L' p7 |$ X travel to Rgv.cpstore
8 Q4 H% E" ]3 } /* Travel onboard vehicle to cpstore */# b( @( N; o6 K
move into Q_store /* Get off vehicle */
# C' ]6 [' S3 p1 Q0 I wait for 20 sec8 X+ E, K9 x0 Z R, r
set A_Time to ac - A_Time3 Q+ J9 F# z& R
print this load, "Time in system " A_Time to message
N9 y& x5 F+ D) g+ p, y inc V_Numdone by 1
/ u% Q; a+ h. ] send to die
k5 Y% L/ m, {# R! n$ Q. d/ Bend
7 d' l) S& V$ I5 W
' p: N: u* Y& [# [% Q: _% b( j% L知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
