|
|
发表于 2009-5-21 20:36:24
|
显示全部楼层
个人想法:
% N2 y* l0 Y; ^1 g约束条件是在上面的Table里面直接输入最大最小值吧。
( W/ e; }6 k; k. R! hMinimum Limit: Table Column 5: The minimum value that this variable can be set to by the Optimizer block. If it is entered without a decimal point, it can only assume integer values. Do not enter limits for variables that are used as results from the model (i.e. Exited from an Exit block).
1 {9 B& V$ |7 `$ {0 D" g" _- `( x2 U: n" |! G
Maximum Limit: Table Column 6: The maximum value that this variable can be set to by the Optimizer block. If it is entered without a decimal point, it can only assume integer values. Do not enter limits for variables that are used as results from the model (i.e. Exited from an Exit block).+ ]2 a. R B O: T2 |* e/ {6 D) e) ~
下面的Equation栏里面应该写入目标函数吧。( m1 ~! z$ J: J3 L, ]. p9 M6 C
MaxProfit (MiniCost)= Var0 + Var1 + Var2; |
|