|
发表于 2009-5-21 20:36:24
|
显示全部楼层
个人想法:$ G( g0 H, U# |; |# ^- b6 E
约束条件是在上面的Table里面直接输入最大最小值吧。& b/ b: T) o2 Y1 q+ E
Minimum Limit: Table Column 5: The minimum value that this variable can be set to by the Optimizer block. If it is entered without a decimal point, it can only assume integer values. Do not enter limits for variables that are used as results from the model (i.e. Exited from an Exit block). e/ t- j0 a a" D! [
4 H) a6 l) U" a+ T/ w6 [Maximum Limit: Table Column 6: The maximum value that this variable can be set to by the Optimizer block. If it is entered without a decimal point, it can only assume integer values. Do not enter limits for variables that are used as results from the model (i.e. Exited from an Exit block).
s: t4 x7 v3 r+ m下面的Equation栏里面应该写入目标函数吧。
' u! M2 {$ ]3 R3 |MaxProfit (MiniCost)= Var0 + Var1 + Var2; |
|