注意报错提示：
; c3 @, `& n. F. h: p& a646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.; G( r4 P9 X1 A) {* P7 X
646.04: Travel action ignored.
8 W- _, g2 l8 n9 e" v2 _# F( n1 E646.04: No debugger information is available.% _; o, f2 w$ e" y A
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.3 g3 K6 _) `: w* C% ^$ k, d
646.04: Travel action ignored.
+ \& w u& X2 ~+ V646.04: No debugger information is available.
7 n# S" y# I+ \5 f1 B' }* f/ J+ F6 S C
回来看代码：
) w! i: ]( O$ ~6 k! P! w6 k, o+ J; a; u, o
begin P_output1 arriving procedure! ~( e4 c- v9 y" T$ O. V
travel to Conv.staoutput1% v, N2 s; K5 @; T
move into Q_output(1) & j6 T' C0 t) n' D
/*Location to wait for a vehicle*// D# w! z) z9 P
travel to Rgv.cpoutput1 /*Get on Vehicle*// Y" r5 |8 |% g m- C- F# J" @
send to P_store
6 V# J, C4 V; s1 G) lend
0 `2 `# \$ q& }/ n3 o' u
( ^( K1 Q, I8 z& R9 G8 Abegin P_store arriving procedure
: [. N, [% m+ f* n! q travel to Rgv.cpstore, j5 e8 a; X6 Z
/* Travel onboard vehicle to cpstore */ x) U1 \5 W" S# C+ T6 D
move into Q_store /* Get off vehicle */& ]" F0 }$ r/ q* m2 g! s
wait for 20 sec5 ^0 J6 \3 h. h( g7 _5 B6 ~1 o+ J
set A_Time to ac - A_Time8 K( s3 Z) s. q9 D0 ]* K
print this load, "Time in system " A_Time to message
) {- O y1 `3 b' M. A- y inc V_Numdone by 14 Q8 n+ ~2 F& ^# I0 s4 t4 C. m5 q
send to die
' J. I* }4 v6 _' U- Mend
* p" o3 o" W" M. R% l9 K) ], k. h2 H
: H" n0 q; x6 C知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
