注意报错提示：7 x) q, x, P6 C! @; a4 O6 U! W6 S
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.0 b8 b8 I0 ~% J9 d1 ^0 _
646.04: Travel action ignored. p8 J* y5 C! }* l& T
646.04: No debugger information is available.
1 r( m1 m: h' \4 X. q0 L646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
3 h1 o9 u+ H- D( S646.04: Travel action ignored.
0 f, F: g8 t, p8 N8 r. p! F3 a646.04: No debugger information is available.* j; Z; Q: K! w4 j/ C7 k% a! q
+ u1 P1 n( i/ }8 n% R0 N
回来看代码：
( ?3 q' U* d0 V- w6 j9 @
9 ^! N* r$ ^1 E2 k' nbegin P_output1 arriving procedure& N, l: h3 c, _6 _7 U+ |* L
travel to Conv.staoutput1; P% P! I8 x A& N, b
move into Q_output(1)
( X5 g" N- t& |; b, |1 S [9 L /*Location to wait for a vehicle*/, n0 p1 @- z# S/ T" V. n
travel to Rgv.cpoutput1 /*Get on Vehicle*/7 u: c0 e' C2 ]# o5 T2 r
send to P_store; a) G/ M; m5 j4 i) j& v
end / g4 X' f- w( W( v/ R
! U) z: A7 n8 c2 h1 ?; ~* {
begin P_store arriving procedure7 r }' r' u* p9 M" X$ L
travel to Rgv.cpstore
3 B( `+ J8 w3 v5 C1 H7 u /* Travel onboard vehicle to cpstore */
: n# l' y) B, h( i, Q% B8 [! K move into Q_store /* Get off vehicle */
+ S; C' @& F) ^/ Z! d t wait for 20 sec" D9 y# G7 \ Z0 \) n9 K M2 \& |# f
set A_Time to ac - A_Time
; J; ?+ k' `. d2 M8 n1 G# I4 I print this load, "Time in system " A_Time to message
4 S' P7 f. A9 \" w2 g: a/ U9 Y inc V_Numdone by 17 l* e1 y0 O6 _5 C( A$ A+ d# T
send to die
) @/ Z9 ?1 n# U1 T8 }; G/ S; }' Bend j8 p) B+ }( K3 z1 P, f1 L
2 i# q/ a, V0 U/ l9 x0 l# M
知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
